Toroidal inductor calculator
Estimate turns, winding envelope, copper usage and DC resistance from core and wire parameters.
1. Design goals
Loaded design parameters from this link.
Installation limits: Ø ≤ 100 mm · H ≤ 100 mm · Hole ≥ 2 mm
2. Core and inductance
Select a manufacturer, material series and model, or search across manufacturers. Missing parameters and bias curves are not inferred. (6420)
Matching models: 4626 · Showing first 100; refine search for more
Catalog parameters · Selected model source
The source does not specify coated limits. Confirm finished core dimensions before relying on the envelope estimate.
The catalog does not specify AL tolerance. Turns use nominal AL; tolerance bounds are unverified. Enter a confirmed tolerance if available.
Micrometals · MP-031040-2 · 7.87 × 3.96 × 3.18 mm · AL 17
View / edit core parameters
Changing core dimensions or AL switches to custom; no bias curve is assumed from a material name.
3. Winding and operating conditions
Insulated diameter is an estimate: bare diameter + 0.06 mm. Confirm with the wire supplier.
Parallel wires, leads and winding settings
4. Design estimate
This winding does not fit the selected geometric model. Reduce turns or wire size, increase coverage, or permit multiple layers.
The catalog does not specify AL tolerance. Turns use nominal AL; tolerance bounds are unverified. Enter a confirmed tolerance if available.
Evidence and winding feasibility
Core parameters from manufacturer catalog; Turns, resistance and copper mass are calculated; envelope and packing are geometric estimates. Parallel wires are side by side; leads, mounts and lead exits are excluded.
AL tolerance: Unknown; nominal inductance only · Core mass: Unknown · Finished wire diameter: Provisional
Bias-curve current: — A · — means no valid model-specific curve. This is not a thermal current rating.
Calculation assumptions
Geometric estimate: concentric layers, side-by-side equal parallel strands, rectangular core cross-section and even coverage. Flat dimensions exclude leads, bobbins, mounting and manufacturing clearance. Wire weight is copper only; total excludes enamel and added insulation. Equal current sharing is assumed.
Current-density reference is not a rated current. Thermal rise, AC copper loss, core loss and insulation ratings are not verified. Validate with a physical sample at the actual frequency, ripple and cooling conditions.
Bias results use a digitized typical KDA curve (1–1,000 Oe, approximate log interpolation), not a guaranteed minimum curve. AL tolerance is applied independently; loaded minimum is a planning estimate. No extrapolation. Zero-bias AL assumes the manufacturer test conditions; uneven winding may differ.
Manufacturer data and method
Micrometals MP-031040-2 · Magnetics — Powder core calculations
Saved designs and comparison
Drafts save in this browser; save up to 4 designs. Clearing browser data deletes them; export files for another device.
| Design | L / I | Turns/layers | OD×H / hole mm | Wire m / copper g | DCR Ω / DC loss W | Loaded L μH | Actions |
|---|
High-frequency and steady-state thermal estimate
Single-winding storage/filter inductors with triangular ripple; not common-mode chokes or transformers. AC resistance factor, core loss density and thermal resistance require manufacturer, simulation or measured evidence.
Evidence has not been confirmed.
Enter valid engineering parameters
